DESIGN AND CONSTRUCTION OF PUNCH AND DIE FOR PRODUCTION OF CUPS

Code No: 176594

₦5,000.00

ABSTRACT

This project is constructed based on careful theoretical analysis of materials of chance and reasons for the selection of the materials.
The theoretical analysis of heat principles and temperatures of the different fervid which in solid stage should set in the mould were analyzed.
The basic principles of cooling of the mould to avoid physical problems of cracks and distortions involved when high temperature are were studied. The cup mould design started with the choice of the optimal dimensions and then production of the wooden pattern.
With the completion of the wooden pattern of dimensions 26cm x 12cm x 5cm, the pattern was filled with chemical treated sand and fired over the oven for complete drying exercise. With the drying operation over, the patterns were filled with the sand and rammed well. The risers and provision for the core were all provided. The upper and lower parts of the pattern were tightly fixed together. The instance of the complete filling and ramming, molten aluminum from the furnace was poured into the pattern. After about one day, the pattern was opened and then the formed cup mould of aluminum produced. The cup mould was further cleaned and polished to give excellent production during use.
The cup mould was taken to Onitsha in a private plastic company, where it was test run and used to produce over low prolits type cups.

CHAPTER 1

CHAPTER ONE
1.0 INTRODUCTION
In recent years, Nigeria lays strong emphasis on the manufacturing of both industrial and household products within the country, rather than on importation of materials of different shapes, patterns uses. The trend towards indigenous products imposed severe action on the banning and clamping down on importation of plastic items and materials of different uses. Thus, the situation results in getting plastic items from outside the country very difficult and more over very expensive.
Nigerian household and industry, is stretched with the necessity for different plastic products. This has been made possible due to the production of different dies and moulds which are used in both light injection plastic productions and blow mould plastic production.
For any item to be produced, whether it is Polyvng Chloride Constituent (PVC), Polypropylene (PP), Polythylen (PE) or Polychloride (PC), the mould must be used for the patterns and shape required.
The possibility of producing materials and plastics fittings or utensils of different colours and shapes is as a result of the production of moulds of different sizes and shapes.
The application of moulds and dies extended into all facts of activities; be it plastic moulds or even moulds for the bottle industry. The automobile industry is able to thrive and make remarkable progress is as a result of the mould and die technology which has made it possible for the production of plastic automobile parts of different sizes and intricate designs. In most cases where fabrications by use of welding and forming, the production of very difficult patterns have been as a result of mould and die production. The domestic homes where all suite of utensil, storage tanks and other accessories are in vogue, the possibility of such arrays of materials in due to the mould technology which is in vogue today. The medical world where materials that are used in the heart support and alternative limb and leg â€“ artificial - technology is in use, is due to advances in the plastic mould technology and engineering.